


Whatever your reasons, adding a wood floor to your concrete porch is a fairly tongue-and-groove with finish nails through the face of the floor boards into the
Jun 25, 2007 Tim Carter, of , demonstrates a really simple way to nail wood to a concrete floor. However,, remember not to drill completely through the slab,, and please , use . What if the lumber is not treated?
Mar 7, 1999 These nails are difficult to drive into hard concrete and they tend to You can also use construction adhesive to glue boards to a concrete wall.
We present to you our Rustic Concrete Wood Grain system. Cementitious overlay placed on any existing concrete in your basement, patio, front porch, No stamping here meaning each and every texture pattern and plank is Nail holes?
Jan 18, 2017 How to hang a picture on concrete or brick. Using this simple nail you can hang anything on cinder block, concrete, cement, or bricks. The THS
For us, using a nail gun to drive masonry nails into concrete was . plate on your walls - lumber will wick moisture up form the slab and the
Because these nails are not strong enough to hammer through concrete, try this option only if your concrete
So we've had this very sturdy but extremely plain looking concrete porch in the . I used 4" nails to attach the balusters to the railings (along with the 2" screws). . If you choose to add a design to your deck and install the planks in any other
Feb 7, 2018 The easiest approach is simply to nail the wood to the concrete. Two common nail options are shown below: the cut nail and the concrete nail.
Nail or screw the rail in place, and then reinstall the fence boards. 10. Splicing a Pour new concrete footing - Repairing Maintaining Fences and Gates. Lastly
Wood dividers in a concrete sidewalk, driveway or patio aren't just original, there may have been nails driven through the dividers to hold them more securely.
Jun 23, 2018 Using concrete nails to nail boards into concrete slabs can be an inexpensive project when you do it manually. With just a hammer drill,
Jun 30, 1989 A-The usual way to build a deck over a patio is to attach wood sleepers or strips to the substituting thinner or thicker sleeper strips, or chiseling off high spots in the concrete. is attached to the sleepers with galvanized or weather-resistant nails or screws. Furring strips are often 1-by-3-inch boards.
There are two basic steps in Deck Over Concrete construction: attach. Construction Heart or Deck Heart redwood 2x4 sleepers to the concrete slab; and nail 2x4
A concrete slab in this condition has to be either broken up and carted away or decked over. This was If you want a standard decking design—all the deck boards running one Drill the holes 1/4 to 1/2 in. deeper than the screw will reach.
Do not use power-actuated fasteners or concrete nails when radiant heat pipes are embedded in the slab. Instead, cut the plywood into 2' by 8' planks and score
Do you need to replace a broken, ugly, stained concrete patio? in place for stability. The screws/nails must penetrate the concrete by one inch or more. Use face fasteners (not hidden fasteners) to attach the deck boards to the sleepers.
Set them and make sure they're level, using wet concrete mixed in a large The deck planks are made to have a gap between them, so use a small nail as your