tongue and groove roof decking spans

CHAPTER 23 WOOD 2014 Florida Building Code ICC

ALLOWABLE SPANS FOR LUMBER FLOOR AND ROOF SHEATHINGa, b .. Two-inch (51 mm) sawn tongue-and-groove decking shall comply with Sections

2 x 6 TIMBER DECKING - Structural Wood Systems

American Institute of Timber Construction standards for tongue-and-groove runs of decking must be continuous over at least three approximately equal spans. This decking is to be installed with tongues upward on sloped or pitched roofs

The Long and Short of Wood Roof Systems - WoodWorks

Sep 30, 2014 the participant will understand how long span roof Code Acceptance for 2, 3 and 4 inch thick Tongue Tongue and Groove Roof Decking.

Sizing roof decking in Timber Framing/Log construction - The

How do you size the thickness of roof decking? In my case I am considering tongue and groove teak decking on 5' rafter spans, 9 in 12 roof

Heavy Roof Decking - Yellow Pine Laminated Decking

Southern Wood Specialties in Flomaton, AL manufactures solid Southern Yellow Pine tongue and groove roof decking according to the American Institute of

Structural Decking - Western Wood Products Association

Tongue & Groove Structural Decking. Structural Decking (also known as "roof decking") - should not be confused with lumber intended for residential and

Chapter 23 - International Code Council

beveled, tongue-and-groove or U-shaped joints. 2303.1.5.2 . loads and spans for service as floor and roof sheathing .. Tongue-and-groove decking shall.

Tongue and Groove Decking The Building Code Forum

Feb 15, 2011 Does anyone have experience using tongue and groove decking for roof sheathing? IRC Table R803.1 lists 1 1/2" T&G for rafter spans up to 72".

Inspecting Roof Panel Sheathing - InterNACHI

Learn how to inspect roof deck sheathing. Tongue-and-groove edges or solid blocking may provide support at the edges. Panel edge clips may be installed to

OSB Design and Application Guide - PFS·TECO

Aug 5, 2018 similar information for OSB used as wall and roof sheathing. Section 4 provides FLOOR SPAN Combination Subfloor/Underlayment. Subflooring . manufactured with a square edge or tongue-and-groove. (T&G) edge.

Plywood Span Ratings

The Span Rating on APA RATED SHEATHING panels appears as two numbers example, may be used for roof decking over supports up to 32 inches on

What is Roof Decking? - Roofing Southwest

Dec 3, 2012 The roof deck is the roofing material between the structural the most common type of roof deck is plywood or tongue and groove wood systems. That is because the large structures tend to span more distance and carry

Installation - Lock-Deck Laminated Decking

Deck. It allows the use of mixed lengths of material on a variety of span condi- Lock-Deck laminated roof or floor applied on top of the tongue-and-groove.

Lock-Deck Laminated Decking - Goodfellow Inc.

The decking is used for ceilings and roofs, as well as for . Simple Spans--This configuration requires specified .. applied on top of the tongue-and-groove.

Technical Bulletin T-4 - Diaphragm and Tectum Roof Decks - BuildSite

2009 and. Tectum roof decks are structural building products. supports and along the tongue and groove joint of planks. Roof Tests where spans are eight foot are Additional diaphragm values are shown in the current roof deck catalog.

Shelton Lock-Deck Laminated Decking - APA – The Engineered

Apr 12, 2017 AITC 112-13 Standard for Tongue-and-Groove Heavy Timber Roof Decking 6) In end spans, 1/3 of all courses of decking shall be free of end

Tongue and Groove Roof Decking - WCD2 - Tiny TIMBERS

TONGUE AND GROOVE ROOF DECKING. Two-Span Continuous. All pieces are supported on three supports. All end joints occur in line on every other support

Product Details

Product List